Takashi Black Silicone Hose 90 Degree Standard Elbow 2¾" (70mm) Air Intake Turbo

Black Silicone
90 Degree Standard Elbow
2¾" Inch I.D. – 5 Inch x 5 Inch Long
70mm I.D. – 125mm x 125mm Long
Premium Quality – Super Low Prices

Available (1) Black or (2) Blue:

• Application: The 70mm (2.75 inch) 90 degree standard elbow suits turbo charge pipe routing, intercooler inlet and outlet connections, and cold air intake systems on performance four-cylinder and six-cylinder builds where the pipe needs a sharp 90 degree direction change at 70mm without any reduction in diameter.

• Size Context: At 70mm I.D., this elbow bridges the gap between the common 63mm and 76mm sizes. It is the correct elbow for builds where the charge pipe system runs at 70mm throughout and a 90 degree turn is required at a specific routing point. Using a 63mm or 76mm elbow on a 70mm pipe would result in either a poor seal or an unnecessary restriction at the direction change point.

• Temperature and Pressure Rating: Rated from -48 degrees C to 260 degrees C with a working pressure of 275 PSI. Handles the sustained heat and boost pressure of turbo and intercooler applications without cracking, hardening or collapsing under load.

• Construction Note: 5mm wall thickness with multi-ply silicone reinforcement throughout. Black exterior with no logo for a clean engine bay finish. The blue interior liner is standard Takashi construction and is not a defect.

• Fitment Note: Both ends of this elbow connect to pipes with an outside diameter of approximately 70mm. The 70mm size is sometimes overlooked in favour of the more commonly stocked 63mm and 76mm sizes. Always measure your actual pipe OD before ordering rather than estimating or rounding to the nearest common size. A 6mm difference in pipe OD is enough to prevent a proper seal.

• What to Pair With It: Use with a 70mm T-bolt clamp at each end. Select a clamp rated for 70mm to 80mm diameter to ensure adequate and even clamping force around the full circumference of the hose.

• Practical Buyer Tip: If your pipe run needs both a 90 degree direction change and a size reduction at the 70mm point, check the Takashi 90 degree reducing elbow range for a fitting that combines both functions in a single piece. If direction change only is what you need and your pipe is 70mm throughout, this standard elbow is the correct choice and will maintain full pipe diameter through the turn without any restriction.

Important Note:
(1) Blue Silicone Hose – Blue on the Outside and Blue on the Inside
Blue Hose has White Takashi logo on the Outside
Some part nos. of Blue Hose have no logo
(2) Black Silicone Hose – Black on the Outside and Blue on the Inside
Black Hose has no logo

Takashi Premium Quality Hand Made Hose - The Very Best Costs Less

Precision manufactured from high grade silicone to ensure outstanding temperature resistance.
Takashi Silicone Hoses are perfect for cooling/heating and charged air applications. They are long lasting and perform brilliantly under extreme conditions.
Takashi Silicone Hoses are an inexpensive and practical performance modification suitable for all types of vehicles.
Takashi Silicone Hose is ideal for motor vehicles and for the serious motorsport enthusiast who wants only the best.

Blue Hose has Takashi logo imprinted thereon.
Black Hose is plain with no logo.