Takashi Black Silicone Hose 90 Degree Standard Elbow 4" (101mm) Air Intake Turbo

Black Silicone
90 Degree Standard Elbow
4 Inch I.D. – 5 Inch x 5 Inch Long
101mm I.D. – 125mm x 125mm Long
Premium Quality – Super Low Prices

Available (1) Black or (2) Blue:

• Application: The 101mm (4 inch) 90 degree standard elbow suits large turbocharger compressor outlet routing, big bore intercooler piping, and high-flow cold air intake systems on heavily modified V8 and six-cylinder performance builds where the charge pipe needs to make a sharp 90 degree direction change while maintaining a full 4 inch diameter throughout.

• Size Context: At 101mm I.D., this is a large format 90 degree elbow suited to builds running full 4 inch charge pipe systems. It is the correct elbow to use when your entire pipe run is 101mm and no size reduction is needed at the turn. Using a smaller elbow at this point would immediately restrict airflow in an otherwise unrestricted system.

• Temperature and Pressure Rating: Rated from -48 degrees C to 260 degrees C with a working pressure of 275 PSI. Built to handle the sustained heat and boost pressure demands of high-output turbo systems without deforming, cracking or collapsing under load.

• Construction Note: 5mm wall thickness with multi-ply silicone reinforcement throughout. Black exterior with no logo for a clean finish in custom engine bays. The blue interior liner is standard Takashi construction and is not a defect.

• Fitment Note: Both ends of this elbow connect to pipes with an outside diameter of approximately 101mm. At this diameter, pipe OD can vary between intercooler brands, turbo manufacturers and custom fabricators. Always measure your actual pipe OD at both connection points before ordering rather than relying on nominal sizing alone.

• What to Pair With It: Use with a 101mm T-bolt clamp at each end. At 101mm diameter, T-bolt clamps are essential for maintaining consistent clamping force under boost pressure. Worm-drive clamps are not suitable for connections at this size.

• Practical Buyer Tip: If your charge pipe run needs both a 90 degree direction change and a size reduction at the same point, the Takashi 90 degree reducing elbow range in 101mm inlet sizes is the correct choice rather than this standard elbow. This fitting is specifically for same-diameter 90 degree turns where no size change is required. Choosing the wrong type at this point is a common mistake on custom builds that results in either a boost leak or an unnecessary restriction.

Important Note:
(1) Blue Silicone Hose – Blue on the Outside and Blue on the Inside
Blue Hose has White Takashi logo on the Outside
Some part nos. of Blue Hose have no logo
(2) Black Silicone Hose – Black on the Outside and Blue on the Inside
Black Hose has no logo

Takashi Premium Quality Hand Made Hose - The Very Best Costs Less

Precision manufactured from high grade silicone to ensure outstanding temperature resistance.
Takashi Silicone Hoses are perfect for cooling/heating and charged air applications. They are long lasting and perform brilliantly under extreme conditions.
Takashi Silicone Hoses are an inexpensive and practical performance modification suitable for all types of vehicles.
Takashi Silicone Hose is ideal for motor vehicles and for the serious motorsport enthusiast who wants only the best.

Blue Hose has Takashi logo imprinted thereon.
Black Hose is plain with no logo.